Keyless Remote FobsKeyless Remote Fobs  
Main PageAll VehiclesSearch Nissan Logo

Nissan Murano Key Fobs


Discount Murano Keyless Entry Remotes


Purchase your Nissan Murano keyless entry remotes and key fobs at lower prices than the Nissan dealership. Find the Nissan Murano keyless remote that will work best for you!


The list above is constantly changing. Check back soon for more updates.

Vehicle Years Key Fob FCC IDs Remote Part Numbers
2003 - 2007 KBRASTU15 28268-5W501, 28268-5W500, 28268-7Z800, 28268-C990A 


Feel free to contact us if you don't see the correct key fob part numbers or let us know what you are looking for and what is on the back of the remote you are trying to replace. We'll add it to our table in an attempt to help our other customers out.
Dealership Website [Visit Site]


Programing InstructionsNissan Murano Key Fob Programming Instructions
Save time and money by programming or reprogramming your key fob for your. You'll find the available programming instructions for your year, make and model remote below and it should only take you a few minutes to complete.

2003, 2004, 2005, 2006, 2007
PLEASE READ CAREFULLY BEFORE TRYING! IF AT anytime YOU MAKE A MISTAKE, START AND STOP YOUR CAR, EXIT THE VEHICLE AND START OVER. THE REMOTE CAN BE ONLY PROGRAMMED WITH A MASTER KEY.

1.SIT IN CAR WITH DOORS AND WINDOWS CLOSED.

2.LOCK DOORS WITH POWER DOOR LOCK SWITCH ON DRIVER'S DOOR.

3.PUT IN AND PULL OUT KEY FROM IGNITION APPROX. 8 TIMES OR UNTIL YOU SEE THE HAZARD/TURN SIGNAL LIGHTS FLASH.(older models lights may flash after 4 or 5 times) YOU NEED TO DO THAT IN LESS THEN 10 SEC.

4.WHEN HAZARD LIGHTS FLASH (ON 2005 AND NEWER MODELS THE GAUGE NEEDLES MAY JUMP A LITTLE INSTEAD), PUT KEY IN IGNITION AND TURN TO THE ACC POSITION.(when your hazard lights flash your car is sending a signal to be received by the remote).

5.PRESS LOCK BUTTON ON THE NEW REMOTE TRANSMITTER, LIGHTS SHOULD FLASH AGAIN.

IF YOU HAVE 2 REMOTES, 1 NEW AND 1 OLD OR 2 NEW ONES, PLEASE CONTINUE WITH STEPS 6 AND 7. IF NOT, SKIP TO END.

6.PRESS UNLOCK BUTTON ON DRIVER'S DOOR, THEN LOCK BUTTON ON DRIVERS DOOR, LIGHTS WILL AGAIN FLASH.

7.PRESS LOCK BUTTON ON 2ND NEW OR OLD REMOTE. LIGHTS AGAIN WILL FLASH.

YOU ARE DONE. EXIT VEHICLE AND TRY YOUR REMOTE. IT WILL NOT WORK FROM INSIDE CAR OR WITH KEY IN IGNITION.

Note: if your hazard lights flash after inserting your key in and out, but you can't get the remote to program, you may have a dead battery or the wrong remote. If instructions do not work, do it again but when you get in - shut the door, buckle seat belt and lock doors, then proceed to put key in ignition



Comments:
Leave us a comment if you're not finding what you need or would like to share some information about your vehicle's remote. We'd like to keep our site updated with all the latest information so if you see an error, let us know.

Kathy says:
09-19-2013
Just bought a 2008 Murano and I always buy a backup remote. I've been bitten too many times not to. If not purchased from the dealer they really aren't that expensive.
 

 
Name:
Comment:
Verification Code:
 

<<- Nissan Maxima Keyless RemotesNissan Pathfinder Keyless Remotes ->>