Keyless Remote FobsKeyless Remote Fobs  
Main PageAll VehiclesSearch Hummer Logo

Hummer H2 SUT Key Fobs


Discount H2 SUT Keyless Entry Remotes


Protect your investment in your Hummer H2 SUT and make sure you have a keyless entry remote. Hummer H2 SUT keyless remotes can come in very handy. Buy and new or used Hummer H2 SUT key fob today!


Please check back soon if you didn't find what you're looking for.

Vehicle Years Key Fob FCC IDs Remote Part Numbers
2002 - 2007 LHJ011 21997127, 15186200, 15186201, 15132197, 15132198, 10377295, 22730827, 15186203


We will add your remote information if it is not listed above. Just contact us or comment below to send us a message. Having the most up to date and accurate remote information is important to us and we strive to provide our customers with the most information possible. Let us know.
Dealership Website [Visit Site]


Programing InstructionsHummer H2 SUT Key Fob Programming Instructions
Not all key fobs are difficult to reprogram. Below you'll find a list of available remote programming directions that you can often times do yourself in only a few minutes. Save money by doing it yourself.

2003, 2004, 2005, 2006, 2007
IMPORTANT: Before entering programming mode, have in possession all of the GM remote transmitters you will be using on the vehicle. Once you program the transmitter, all previous codes will be erased from the memory if not reprogrammed during the same programming procedure. The other transmitters will not be functional until you program the transmitters again with new remote.

1. Close all vehicle doors.

2. Insert the key into the ignition.

3. Hold down the power UNLOCK button on the driver's door panel and -continue to hold down until instructed to release.

4. Perform steps 5 through 8 in fairly rapid succession.

5. Turn the ignition switch to the ON position (as far as you can go without starting the engine).

6. Turn the ignition switch to the OFF position.

7. Turn the ignition switch to the ON position.

8. Turn the ignition switch to the OFF position.

9. Release the power unlock button on the door panel. The vehicle will lock and unlock the doors automatically to confirm remote programing or learning mode.

10. Hold down the LOCK and UNLOCK buttons on the remote transmitter simultaneously until the door locks and unlocks. This step may take up to 30 seconds.

11. Repeat the previous step for each additional car transmitter (including any existing transmitters).

12. Turn the ignition switch to the ON position in order to exit the transmitter programming mode.

2008, 2009
Switch ignition ON.

Repeatedly press vehicle information button (it is usually located on the right or left from the steering column depending on year make and model) Fig. 2 [A] until PRESS TO RELEARN REMOTE KEY is displayed.

Press set/reset button Fig. 2 [B] until REMOTE KEY LEARNING ACTIVE is displayed.

Programming mode activated, proceed as follows:

Press and hold LOCK and UNLOCK remote buttons on first remote transmitter simultaneously for 15 seconds.

Wait for acoustic signal (indicates correct programming).

Repeat above procedure to program remaining remote transmitters.

Switch ignition OFF to exit programming mode.

Remote transmitters can also be programmed using diagnostic equipment.

NOTE: A maximum of 8 remote transmitters can be programmed.



Comments:
Leave us a comment if you're not finding what you need or would like to share some information about your vehicle's remote. We'd like to keep our site updated with all the latest information so if you see an error, let us know.


No comments have been submitted. Add yours today!

 
Name:
Comment:
Verification Code:
 

<<- Hummer H2 Keyless RemotesHummer H3 Keyless Remotes ->>